MemTech Pro Liquid Gas Barrier Membrane 15kg
Liquid Gas Barrier
MemTech Pro liquid gas barrier can be used to protect most building surfaces from the effect of liquid and water vapour, carbonation and as a gas barrier to prevent the ingress of Methane, CO2 and Radon. As a product that is a barrier to moisture, MemTech Pro liquid gas barrier can also be used as a DPM on floors and walls. The product is also suitable for certain waterproofing applications.
Benefits of MemTech Gas Barrier:
- Suitable for new and existing structures
- 3rd Party Accredited/independently tested
- Complies with BRE 211:2015 & BS8485:2015
- Suitable for use as gas protection for NHBC GREEN, AMBER 1 and AMBER 2 site characteristics.
Application of MemTech Gas Barrier
MemTech Pro liquid gas barrier must be applied to a clean, sound and dust free surface. Any defects in the surface should be addressed first. The surface should be smooth or have a light, even texture and masonry should be flush pointed.
Wet conditions and inclement weather can have a negative effect on the MemTech Pro liquid gas barrier whilst it’s drying and therefore, these conditions should be avoided. Memtech liquid gas barrier should not be applied in temperatures below 7 degrees. Memtech liquid gas barrier can be applied by brush, roller or spray and a minimum thickness of 1.0mm must be achieved to provide a gas barrier. Where multiple coats are applied it is recommended that the coats are applied at right angles to each other. The second coat should not be applied until the first coat becomes touch dry. This time can vary depending on site conditions. Typical drying times of 1-2 hours in favorable conditions. Second coats should be applied within 24 hours of the first coat.
Waterproof and Dry - Trusted independent supplies of Delta Products.
If you have any technical questions about Memtech Pro Liquid Gas Barrier, call our expert team on 0203 947 2972. Find out more about Delta Gas protection or browse our full range of Delta Gas products.
- Acts as a damp proof membrane
- Used for damp proofing and gas proofing
- Provides protection against a variety of ground gases
|Dillution||Ready to use|
|Coverage||To achieve 1.0mm thickness, a total of 2kg/m2 is required, therefore a 15kg tub will cover an area of 7.5m|
|Country of Manufacture||United Kingdom|
Thank you for leaving a review on this product!
If you need more help, check out the downloads for more product information, or our fantastic Help & Advice centre!
Review this product
Share your thoughts about this product with other customers, write a review.